Friday, June 29, 2012

cell phone jammer is still valid when performing the specified plan

Urban 723,734 or two tandem offices relay switch rate from 73% to 67% by the traffic analysis found that the two Board to relay congestion each two hundred times, each line traffic to reach 0.75Erl / l. Of this situation, the two bureaux to the increase in two relay per line traffic is reduced 0.4Erl / l relay congestion reduced to 0, the relay switch rate back to normal. Usually pay attention to the analysis of traffic and make appropriate adjustments in a timely manner, improve the system through rate, an important method for optimizing mobile networks. Solve the network congestion, we have adopted the general establishment of new stations in high traffic areas (such as addition of a micro-cellular), to adjust the high congestion station antenna height and the pitch angle to increase the carrier frequency and other district of high congestion.The button is set in the main control software
Traffic control purposes is reported to the traffic load to limit the number of residential access request is divided into the TCH flow control, the RACH flow control, the SSM flow control three kinds. Congestion occurs when the district was occupied by the radio resource to the default threshold, part of the MS access request was blocked. With the district's congestion mitigation or MS move to the adjacent cell, they can normally apply for services. The following is only for practice TCH flow control, the last two flow control with similar processing principles. In the flow control process, the two clocks to control the access level of interception and recovery.cell phone jammer  is still valid when performing the specified plan
0 - no congestion to ease the processing; 1 to 100 - to reach this threshold, has started to ease handling; 101 - when all TCH was occupied and there are more than one TCH to apply, has started to ease processing. Reduce the threshold, it will speed up congestion relief. This is the parameters of the adjacent areas in the congested switch. When the serving cell congestion, to make switching to the target cell more easily it set below the switching threshold value; and vice versa so that the value is higher than the threshold value. This parameter is set to 1 if you need emergency switch, the district will re-to the previously refused the handover request of the target cell to initiate switching applications. This parameter is set to 0:00, when the district refused the request of the adjacent areas of the switch itself congestion.cell phone jammer  is controlled by groups

No comments:

Post a Comment